11/8/2022 0 Comments Bitcomet blocked by comodo![]()
Click on the “Apply” button, then choose “Log Out. Click “Add” in the “Inbound Services” section. ![]() Set the “WAN Users” to “Any” and select “Apply.”ġ0. Enter the IP address you created into the box provided. Set the “Action” option to “Allow Always” and the “LAN Users” option to “Single Address.”ĩ. Click on “Firewall Rules”, click on “Add” in the “Outbound Services”. Open BitComet, click Options Advanced Connection CHECK Enable DHT Network Click OK Look at the status of the DHT network at the bottom right hand corner. Enter the number you just noted down from Bitcomet into both the “Start Port” box and the “Finish Port” box. Open BitComet, click Options Advanced Connection UNCHECK Enable DHT Network Click OK Close BitComet to allow saved changes to take place. Set the “Type” option to “TCP/UDP” and name it.Ħ. Click on “Services- Add Custom Service.”ĥ. Keep “Enable UPNP Port Mapping” unchecked.Ĥ. Open Bitcomet, go to”Tools-Options.” Note down the number in the “Listen Port” box.Ģ. Enter the two sets of numbers you’ve just noted down. Enter “192.168.0.X” into the “IP Address” box, replacing “X” with a number except 1.ħ.Enter “255.255.255.0″ into the “Subnet Mask” box and “192.168.0.1″ into the “Default Gateway” box.Ĩ. Click on the “Use the Following IP Address” radio button.Ħ. Go to “Start- Control Panel-Network and Internet Connections”, right click on Internet connection and go to “Properties-Internet Protocol-Properties ”ĥ. Look for “Domain Name Server” and note the two sets of numbers next to this.Ĥ. Bitcomet blocked by comodo password#After it prompted, enter your username and password from the back of router.ģ. You can find this on the back of your router.Ģ. Open the Internet address of your router with your browser. Log in to Your Router
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |